Ultraplus Adhesive 25 Kg

FIELDS OF USE
THERMO NETPER ADHESIVE ULTRAPLUS is used to bond cladding materials such as low water absorption ceramics and low water absorption cement-based plaster, screeds and primed concrete on solid, dust-free, vertical or horizontal surfaces. It is especially used in areas exposed to heavy traffic to bond granite, marble, terracotta, natural stone and other similar, low water absorption cladding materials on horizontal and vertical surfaces in indoor and outdoor settings.

APPLICATION
The surface must be dry, clean, solid and free of dust; oil, dirt or materials that prevent adhesion must be completely removed from the surface and any mortar and cement residues must be scraped off.

APPLICATION INSTRUCTIONS
Mixing ratio: it must be mixed with water in a ratio of 24-26% by weight (6.0-6.5 litres of water for a 25 kg bag). Electric mixer at low speed (400 rpm). Mixer with special tip: the product must be mixed with a low speed mixer so that no dry powder or lumps remain. Leave the mortar to rest for 5-10 minutes and mix again for 1-2 minutes before use.

ENVIRONMENTAL IMPACTS
Not classified as dangerous.

STORAGE TRANSPORT
Protect against frost, rain and other atmospheric agents. One pallet with 60 bags is equivalent to 1,500 litres.

ISSUES TO BE CONSIDERED
Avoid application under strong wind or sun. The time increases at low temperatures and the time decreases at high temperatures. It should not be applied on frozen, melting or freezing surfaces within 24 hours. Appropriate plaster mesh should be used at different material junctions and points where movement may be considered.